MICRO-EPSILON TIM 160 Especificações descarregar pdf (Página 31)

thermoIMAGER TIM 31

The process interface has an integrated failsafe mode. This allows to control conditions like interruption of

cables, shut-down of the software etc. and to give out these conditions as an alarm.

Controlled conditions on camera and software

Standard Process interface

TM-PIF-TIM

Industrial Process interface

TM-PIF500V-TIM

Interruption USB cable to camera √ √

Interruption data cable camera - PIF √ √

Interruption power supply PIF √ √

Shut-down of TIMConnect software √ √

Crash of TIMConnect Software

- √

Failsafe output 0 V at analog output (AO) Open contact (alarm relay)

It is possible that some malfunctions of the software under certain circumstances cannot be detected. Therefore a 100%

software crash control cannot be guaranteed.

The failsafe function can be activated in the Analog Output

settings. The checkbox Stop fail-safe pulse on alarm must be

activated, if the analog output should be used in addition as an

alarm output for a temperature alarm. In case of an alarm the

alternating fail-safe pulse signal will stop and the set voltage

level will be given out as constant value. (Industrial PIF only)

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 83 84

Sem comentários

MICRO-EPSILON TIM 160 Especificações Página 31